Standard Dry Cleaning Conveyor Specifications

GENERAL

Conveyor can be configured to fit your "envelope" (length, shape and offset height of your facility). Conveyor can utilize horizontal or multi-level shape.

Conveyor can be floor and/or ceiling supported.

Rigid frame with two 1 ‡ " x 2" x 3/16" foundation angles. All horizontal bends re-enforced with 2" x º" flat bars.
Conveyor track is 1-5/16" O.D. x 13 Gauge welded steel tubing, zinc plated to prevent corrosion. Cross members are 3" steel channels.

White Conveyors are available in a wide variety of special shapes. You can “design your own conveyor” to fit most any length or shape by using our standard “modular” sections. Here are some typical shapes.

 

DRIVE CONFIGURATIONS:

• 180 Degree end drive OR
• In-line "TWIN" caterpillar drive(s) for heavy duty loads with optimized chain pull distribution.
• Integral flame cut steel sprocket with 1-1/4" minimum shaft diameter.
• All configurations use DIRECT DRIVE.

DIRECT DRIVE

• The conveyor drive is fractional horsepower maintenance free, low noise DIRECT DRIVE (Integrated motor-reducer assembly with Inverter).
• Totally Enclosed Fan Cooled motor.
• Permanently lubricated reducer.
• Single Phase (115/230) voltage or three phase (230-460) voltage.

CONVEYOR CHAIN:

• Single or two tier chain configuration are available.
• Each 12" conveyor chain frame has 3, 5 or 10 slots to separate orders.
• Conveyor chain frames are steel, aluminum, or nylon, depending customer's requirements.
• All conveyor frames have hardened hinge pins and low friction spacers to minimize wear.
• Conveyor frames equipped with die cast aluminum yokes with load bearing wheels 1-3/8" diameter with nylon tires on steel cores.
• Stabilizing rollers mounted on the underside of the yoke provide positive tracking of chain.

ELECTRICAL:

The electrical circuit has been approved and listed by ETL(UL)/CE. Inverter drive control provides following features:

• Soft Start/Stop
• Variable speed
• Adaptable Jam Protection
• Low energy consumption

OPERATING CONTROLS (Low Voltage):

• Bi-directional handswitch: a three position switch for clockwise and counter-clockwise movement, with Stop in center position.
• Optional bi-directional foot switch to activate conveyor in either clockwise or counter-clockwise direction when foot pressure is exerted and maintained by operator.

OPTIONAL EQUIPMENT

Automatic Control:

White Conveyors microprocessor keyboard control automatically sends a signal that starts and stops the conveyor at the designated position when the required slot number is entered. The conveyor will rotate either clockwise or counter-clockwise, traveling via the shortest route to position. When two or more operator stations are required, lock-out feature is included.

Hand Switch - mounted on arm extending from conveyor.

Series 600 Control - selects garment automatically by shortest route. All solid state.

Foot pedal - with 25 ft. of cord.